Poultry house steel structure calculator: full guide
This guide explains what the poultry house steel structure calculator computes, how each input changes the result, and how to turn the output into a comparable request for quotation. Worked examples below are produced with the same engine that powers the live tool.
Replace the default values in the poultry house steel structure calculator with your own flock size, targets and local costs. Defaults are commercial-sector averages, not a recommendation.
2
Compare the three scenarios
Switch between conservative, expected and optimistic to see how sensitive the result is to your assumptions before committing capital.
3
Read the assumptions
Check the assumptions panel so you know what the model excludes — typically taxes, import duties, special civil works and land.
4
Turn the output into a quote request
Put the figures into one written project request. Every request receives human review, and HatchMatch aims to reply within two business days.
Every input explained
Default values are commercial-sector averages. Replace them with your own figures — your data always overrides the defaults.
House length (m)
120
House width (m)
15
Eave height (m)
3
Number of houses (houses)
4
Frame spacing (bay) (m)
6
Steel price (USD/t)
1,300
Sandwich panel price (USD/m²)
22
Worked examples
Three realistic cases, computed live with the calculator engine.
Baseline case
Reference values under the expected scenario — a good starting point for a first project.
Inputs
House length120 m
House width15 m
Eave height3 m
Number of houses4 houses
Frame spacing (bay)6 m
Results
Steel tonnage — total project158.4 t
Shell material cost — total projectUSD 443,520
Portal frames per house21
Steel tonnage per house39.6 t
Scale-up case
The same project with flock size increased 2.5×, to show how the result scales.
Inputs
House length300 m
House width30 m
Eave height3 m
Number of houses10 houses
Frame spacing (bay)6 m
Results
Steel tonnage — total project1,980 t
Shell material cost — total projectUSD 5,088,600
Portal frames per house51
Steel tonnage per house198 t
Conservative case
Reference values under the conservative scenario, with a safety margin on performance.
Inputs
House length120 m
House width15 m
Eave height3 m
Number of houses4 houses
Frame spacing (bay)6 m
Results
Steel tonnage — total project201.6 t
Shell material cost — total projectUSD 499,680
Portal frames per house21
Steel tonnage per house50.4 t
Planning assumptions
The poultry house steel structure calculator uses common commercial-sector parameters; your own measured data always overrides the defaults.
The conservative scenario adds a safety margin; the optimistic scenario assumes favourable operating conditions.
Taxes, import duties, special civil works and land cost are excluded unless stated otherwise.
It is a class-4 planning estimate (roughly ±30%). Use it to compare options, size an investment and prepare a quotation request — it does not replace engineering design or a bankable feasibility study.
Yes, that is the intended use. Turn the results into a requirement list and send a single request to receive comparable offers from qualified third-party manufacturers. Any firm quote overrides the estimate.
Yes. Climate, grid voltage and stability, labour cost, import duties and logistics all move both the sizing and the cost. State the country in your request so the adjustment is priced into the offer.
Use the guide to understand the inputs and see worked examples, then run the calculator with your own figures. Both pages are free and require no registration.
Convert it into a requirement list and send one request for quotation. You receive comparable offers from qualified third-party manufacturers, and each firm quote replaces the estimate.
